风管68m直管运输方案.doc

LIFTING AND TRANSPORTATION DIRECTION OF LINE1 DUCT (CE1CB05 EL+68m) BETWEEN BAGHOUSE FAN AND STACK 1号线 Project No. : CM8896 Project Name: KONIAMBO NICKEL PROJECT Customer : EQUIP KONIAMBO Site : NEW CALEDONIA 00 14.JAN.2012 For Approval SHAOYT REV. DATE DESCRIPTION PREP’D CHK’D APP’D APP’D DATE CLIENT  目 录 TABLE OF CONTENTS 1、概述General 4 2、参考文件REFERENCE DOCUMENTS 4 3. 施工内容 Items to be installed 4 4、吊装注意事项LIFTING PRECAUTIONS 4 5、安装前准备PREPARE FRONT OF INSTALL 5 6、吊装步骤LIFTING STEPS 5   PLEASE REMOVE IF DOCUMENT REV IS NOT 00 OR ABOVE REVISION HISTORY REV.NO Revision Date Revision Details 00 Issued For Construction 概述General This article offers guideline for lifting and transporting of LINE1 DUCT BETWEEN BAGHOUSE FAN AND STACK (CE1CB05 EL+68m). 此方案描述了1号线方法。 2、参考文件REFERENCE DOCUMENTS EK公司给的图纸Drawings by EK。 319000-00300-A2001-4100-0007-施工内容 Items to be installed F4、吊装注意事项LIFTING PRECAUTIONS 4.1 All the heavy lifting equipment, slings and pulleys must be subject to careful calculation and inspection prior to use. 施工前，所有起重搬运机具、钢丝绳和滑轮等，必须经过检验和验算，证明确实可靠后方可使用。 4.2 Operation for the heavy equipment must strictly follow the safety rules relevant to operation and construction. 操作起重机械，必须严格遵守安全操作规程及有关施工安全规定。 4.3 Do not overload any lifting equipment. 所有起重机具，不得超负荷使用。 4.4 The equipment shall be lifted according to the sling point specified by the anufacturer. If such hoisting position is not clearly stated, center of gravity shall be determined. 起吊设备时，必须按设备出厂标志的吊装位置起吊，无明显标志时，应事先找好重心，确定受力部位 4.5 When 2 or more slings are used for lifting, each sling shall take equal stress; the angle between perpendicular and stress direction shall be no bigger than 300 用两根以上的钢丝绳起重时，每根钢丝绳受力应均匀，并与垂线所成的夹角不得大于300 4.6 Slings for equipment lifting shall not contact directly with the corners and finish surface of the equipment. Pads shall be applied on these points, in order to prevent damage to the finish surface and wir