套管----种类及用途.pptVIP

 NANJING ZHIDA ELECTRIC CO..LTDAug.1 2010 Bushing Device that enables one or several conductors to pass through a partition such as a wall or a tank, and insulates the conductors from it; the means of attachment (flange or fixing device) to the partition forms part of the bushing .Applied placeTransformer、reactor、switch、circuit breaker、 transformer-cable terminal、through a wall or floor 。      Structure of other brand bushing     The typical failures of transformer bushings * * main insulation 1.Condenser bushing 2.Un-Condenser bushing a ) Oil impregnated paper（OIP） condenser bushing ★ b )Epoxy resin impregnated paper （RIP）condenser bushing c )Gas-insulated bushing d )Liquid-filled bushing e )Cast bushing f )Combined insulation bushing TYPE OF BUSHINGS BUSHING FOR GIS HIGH CURRENT BUSHING Other bushings Oil-Oil bushing (RIP) Oil-SF6 bushing (RIP) transformer cable boxes GIS transformer OIPRIP CONGDENSER TRANSFORMER BUSHING transformer Type of transformer bushings Oil-Air bushing (OIP) Oil-Oil bushing (RIP) Oil-SF6 bushing (RIP) The bushing is built up around a centre tube on which the condenser body is wound, The upper insulator, lower insulator, top chamber and mounting flange are held between the end plates by the centre tube. ◆ Oil-impregnated paper bushing. ◆ Porcelain insulator. ◆ High quality transformer oil fills the space between the condenser body and the porcelain. ◆ Sealing is accomplished by oil-resistant rubber gaskets in grooves. ◆ The mounting flange is equipped with a test tap.The top chamber is equipped with an oil level gauge. ◆ The lower end is shielded by a separated shield. ◆ Draw-lead（rod) or solid rod conductor connection. ◆ The bushing is mounted with an inclination of maximum 30 degree from the vertical. Oil-Air bushing (OIP) 1、Outer terminal 2、Top chamber 3、Set of springs 4、Air side porcelain insulator 5、Condenser