AD9851串口程序.docVIP

#include reg52.h /****************51串行驱动****************/ sbit clk =P1^1; sbit fq_ud =P1^2; sbit rst =P1^3; sbit dat =P1^0; //sbit key1 =P3^3; //sbit key2 =P3^4; //sbit key3 =P1^6; //sbit key4 =P1^7; unsigned char phase_word=0x00; //相位控制字，使用低5位 unsigned char power_down=0x00; //低功耗模式 unsigned char mult=0x00; //6倍频打开 unsigned char ww[5]={0x09,0x0E,0x38,0xE3,0x8E}; unsigned long freq,set_value; void delay_us(unsigned int i) //delay { while(i--); } //AD9851初始化，在此之前请确认D0,D1和D2的电平状态 void init_dds(void) { rst=1; //高电平复位 delay_us(10000); //延时10mS rst=0; delay_us(10000); //延时10mS clk=0; fq_ud=0; delay_us(2); clk=1; //送入W0 delay_us(2); clk=0; delay_us(2); fq_ud=1; //使能 delay_us(2); fq_ud=0; delay_us(2); delay_us(10000); } //往AD9851写数据 void write_dds(unsigned long dds) { unsigned char i,j,temp; ww[0]=dds0xFF; //频率字最低字节 ww[1]=(dds8)0xFF; ww[2]=(dds16)0xFF; ww[3]=dds24; //频率字最高字节 ww[4]= (phase_word3)|| power_down2 || mult; //控制字 fq_ud=0; //FQ_UD置低 clk=0; //CLK置低 for(i=0;i5;i++) //送入5个字节的控制字 { temp=ww[i]; for(j=0;j8;j++) { clk=0; if(temp0x01)dat=1; else dat=0; delay_us(2); clk=1; delay_us(2); temp=1; } } clk=0; fq_ud=1; //使能信号 delay_us(3); fq_ud=0; } //写入频率 void write_freq(unsigned long freq) { unsigned long dds; dds=128.861905*freq; //频率字计算,可进行微调 // dds=214.7483648*freq; write_dds(dds); } main() { //unsigned long a=0,b=0; P0=0xff; P1=0xff; delay_us(10000); init_dds(); write_freq; while(1) { //if(key1==0) //{delay_us(10000); //while(!key1); //{a+=100000; //write_freq(a);}} //if(key2==0) //{delay_us(10000); //while(!key2); //{b+=5000; //write_freq(b);}} //if(key3==0) {delay_us(10000);while(!key3);write_freq(12000);} //if(key4==0) {delay_us(10000);while(!key4);write_freq(19000);} }