风力异步发电机外文文献.pdfVIP

Available online at ScienceDirect Journal of Electrical Systems and Information Technology 4 (2017) 257–268 Analysis of wind driven self-excited induction generator supplying isolated DC loads Khaled S. Sakkoury a,∗, Safaa Emara a , Mohammed Kamal Ahmed b a Department of Power Electronics and Energy Conversion, Electronics Research Institute, Dokki, Giza, Egypt b Department of Electrical Engineering Al-Azhar University, Cairo, Egypt Received 29 July 2016; received in revised form 2 August 2016; accepted 9 August 2016 Available online 11 October 2016 Abstract This paper presents the analysis, modelling and simulation of wind-driven self-excited induction generator (SEIG). The three-phase SEIG is driven by a variable-speed prime mover to represent a wind turbine. Also, the paper investigates the dynamic performance of the SEIG during start-up, increasing or decreasing the load or rotor speed. The value of the excitation capacitance required for the SEIG is calculated to give suitable saturation level to assure self-excitation and to avoid heavy saturation levels. Matching of the maximum power available from the wind turbine is performed through varying the load value. The effect of AC–DC power conversion on the generator is investigated. The system simulation is carried out using MATLAB/SIMULINK toolbox program. © 2016 Electronics Research Institute (ERI). Production and hosting by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (/licenses/by-nc-nd/4.0/). Keywords: Wind system; Self-excited induction generator; Excitation capacitor control; Uncontrolled rectifier; DC