IPv6隧道配置.docVIP

IPv6 Tunneling Configuration | IPv6隧道配置 关键字 IPv6隧道配置 IPv6 Tunneling 拓朴 实验说明 　　R1,R2,R3在IPv4的OSPF AREA0中 　　现在在R2与R3上实现IPv6的隧道,穿越IPv4核心网 配置 R1的配置 !hostname R1!interface FastEthernet0/0ip address 172.16.0.1 255.255.255.0duplex half!interface Serial2/1ip address 192.168.0.1 255.255.255.0serial restart-delay 0!router ospf 64log-adjacency-changesnetwork 0.0.0.0 255.255.255.255 area 0! R2的配置 !hostname R2!interface Tunnel0no ip addressipv6 address AAAA::1/128tunnel source 192.168.0.2tunnel destination 172.16.0.3!interface Serial2/1ip address 192.168.0.2 255.255.255.0serial restart-delay 0!router ospf 64log-adjacency-changesnetwork 0.0.0.0 255.255.255.255 area 0!ipv6 route ::/0 Tunnel0! R3的配置 !hostname R3!interface Tunnel0no ip addressipv6 address AAAA::2/128tunnel source 172.16.0.3tunnel destination 192.168.0.2!interface FastEthernet0/0ip address 172.16.0.3 255.255.255.0duplex half!router ospf 64log-adjacency-changesnetwork 0.0.0.0 255.255.255.255 area 0!ipv6 route ::/0 Tunnel0! 调试 R2上进行调试 R2#show int t0Tunnel0 is up, line protocol is up Hardware is TunnelMTU 1514 bytes, BW 9 Kbit, DLY 500000 usec, reliability 255/255, txload 1/255, rxload 1/255Encapsulation TUNNEL, loopback not setKeepalive not setTunnel source 192.168.0.2, destination 172.16.0.3Tunnel protocol/transport GRE/IP, key disabled, sequencing disabledTunnel TTL 255Checksumming of packets disabled, fast tunneling enabledLast input 00:06:11, output 00:06:11, output hang neverLast clearing of show interface counters neverInput queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0Queueing strategy: fifoOutput queue: 0/0 (size/max)5 minute input rate 0 bits/sec, 0 packets/sec5 minute output rate 0 bits/sec, 0 packets/sec9 packets input, 972 bytes, 0 no bufferReceived 0 broadcasts, 0 runts, 0 giants, 0 throttles0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort9 packets output, 972 bytes, 0 underruns0 output errors