pathfinder 疏散软件入门教程 stairwell 楼梯绘制.pdfVIP

403 Poyntz Avenue, Suite B Manhattan, KS 66502 USA +1.785.770.8511 Stairwell Example Pathfinder 2011 Stairwell Example This example represents an outer section of a dormitory wing with 30 persons randomly distributed inside. The persons will move through their respective halls and down a stairway to exit the model. Create Floor Geometry To select Metric measurements: 1. On the View menu, click Units and select SI. To specify snap grid spacing: 1. On the View menu, click Edit Snap Grid 2. In the Snap grid spacing box, type 1.0 m. 3. Click OK. To create the room with a hallway: 1. In the View toolbar, click Top View ( ). 2. In the Tools toolbar, click Add a Rectangular Room ( ).Note: Using a double-click makes the tool sticky, that is, it remains selected so that we can add multiple rooms without selecting the tool every time. This is indicated by the small green dot on the tool. To unselect the tool, select another tool or press ESC. 3. We will make a large room and then subdivide it. To add the first room, click and drag from point (4, 0) to point (18, 8). 4. Create four additional rooms from ( 4,0) to (11,3), (11,0) to (18,3), ( 6,5) to (12,8), and (12,5) to (18,8). Note: When we draw new rooms on top of an existing room, the new room is cut out from the existing room. By first drawing the base room and then drawing new rooms, we have automatically created a connected hallway. 5. Create the base of the stairwell by drawing a rectangular room from (2,6) to (4,8). 2 Figure 1: Geometry of ground floor To quickly make the second and third floors, we will copy the ground floor. For convenience and to help or