反应釜毕业设计_精品.pdfVIP

摘要 本设计依靠《化工设备设计手册》和 GB150-2010 等文献，先行设计筒 体和封头部分，筒体和封头均采用 0Cr Ni Mo Ti 材料，厚度为 14mm，封 18 12 2 头采用椭圆形封头，夹套采用Q235-B 材料，厚度为10mm，筒体、夹套、封 头分别经过气压和液压校核。装液高度超过了最佳装液高度，因此采用双层 搅拌，搅拌形式均选择圆盘涡轮搅拌器，因为双层桨的旋转偏心度过大，所 以采取了底轴承固定措施。换热方面，因为夹套提供的换热面积不能满足传 热要求，所以筒体内部采用蛇管加以增大传热系数。根据设计参数选择了单 支点机架，填料密封，电动机功率为4KW ，封头安装了人孔、视镜、温度表。 关键词：反应釜 聚氯乙烯 蛇管 设计 I Abstract According to Chemical Equipment Design Manual and GB150-2010 and other documents, Cylinder and head is designed firstly, the cylinder and head are used 0Cr18Ni12Mo2Ti material, thickness of 14mm, with oval- shaped head, jacket with Q235 -B material, thickness of 10mm, After air pressure and hydraulic testing cylinder, sleeve, head were checked. Liquid filling height is more than the best liquid filling height, so the design use s double mixing, stirr ing forms is disk turbine agitator, because the rotation of the eccentric double -paddle is too much, so the measures taken by the end of the fixed bearing. Heat transfer, since the heat transfer area heat provided by the transfer jacket can’t meet the requirements, so the serpentine tube is taken to cylinder to increase heat transfer coefficient. According to the design parameters, choosing a single pivot frame, packing seal, motor power of 4KW, manholes, viewing lens, thermometer. Keywords ：reactor ；PVC ：serpentine tube ；design II 目录 摘要 I ABSTRACT II 第一章 绪论 1 1.1 反应釜概况 1 1.2 国内外研究现状2 1.2.1 国内2 1.2.2 国外3 1.3 前景与展望4 第二章 反应釜釜体结构的设计计算6 2.1 罐体和夹套的设计计算6 2.1.1 几何尺寸的设计计算6 2.1