第二章数控加工程序编制2.pptVIP

编程实例：零件的厚度10mm，起刀点的坐标为X0，Y90.0；所用铣刀为T10，刀补参数存于D10。（假设刀具已选好并已装刀主轴上；测出工件原点与机床原点的距离存入G54。） 零件加工程序： % MPE 100 LF N10 G54 G90 G00 X0 Y90.0 S56 M03 LF N20 G17 D10 Z-11.0 LF N30 G01 G41 D10 X30.0 Y90.0 F500 LF N40 G91 X30.0 Y30.0 LF N50 G02 X30.0 Y-30.0 I0 J-30.0 LF N60 G01 X30.0 Y0.0 LF N70 G02 X30.0 Y30.0 I30.0 J0.0 LF N80 G01 X-15.0 Y-30.0 LF N90 X15.0 Y-30.0 LF N100 X-30.0 Y0.0 LF N110 X-30.0 Y-30.0 LF N120 X-45.0 Y30.0 LF N130 X-15.0 Y30.0 LF N140 G40 G90 X0.0 Y90.0 LF N150 G53 G00 D0 Z0 M05 LF N160 M02 LF 附：OpenSoftCNC 01T 系统功能指令代码 1、三点圆弧插补指令G05 X Z I K F ；I、K：圆弧上任