【精选】zemax常用评价函数操作数zemax常用评价函数操作数.docVIP

Operand Definitions ZEMAX supports optimization operands which are used to define the merit function. Each operand may be assigned a weight which indicates the relative importance of that operand, as well as a target, which is the desired value for that operand. The operands are listed below. ABSO: Absolute value 绝对值 ACOS: Arccosine AMAG: Angular magnification 角放大率 ANAR: Angular aberration ASIN: Arcsine ASTI: Astigmatism　初级像散 ATAN: Arctangent AXCL: Axial color BLNK: Blank BSER: Boresight Error COGT: Conic greater than COLT: Conic less than COMA: Coma 初级彗差 CONF: Configuration # CONS: Constant 常量 COSI: Cosine COVA: Conic value CTGT: Center thickness greater than 中心厚度(间隔)大于 CTLT: Center thickness less than 中心厚度(间隔)小于 CTVA: Center thickness value 中心厚度(间隔)等于 CVGT: Curvature greater than 曲率大于 CVLT: Curvature less than 曲率小于 CVOL: Cylinder volume CVVA: Curvature value 曲率等于 DENC: Diffraction encircled energy DENF: Diffraction encircled energy fraction DIFF: Difference DIMX: Distortion max 最大畸变 DISC: Distortion calibrated DISG: Generalized distortion DIST: Distortion 畸变 DIVI: Division DLTN: Delta N DMFS: Default merit function start 默认评价函数起始点 DMGT: Diameter greater than 直径大于 DMLT: Diameter less than　　直径小于 DMVA: Diameter value　　直径值 DXDX: Derivative Dx/Dx DXDY: Derivative Dx/Dy DYDX: Derivative Dy/Dx DYDY: Derivative Dy/Dy EFFL: Effective focal length 有效焦距 EFLX: Effective focal length x x方向焦距 EFLY: Effective focal length y　　y方向焦距 ENDX: End execution ENPP: Entrance pupil position 入瞳位置 EPDI: Entrance pupil diameter 入瞳直径 EQUA: Equal ETGT: Edge thickness greater than 边缘厚度大于 ETLT: Edge thickness less than 边缘厚度小于 ETVA: Edge thickness value 边缘厚度等于 EXPP: Exit pupil position 出瞳位置 FCGS: Field curvature, generalized, sagittal FCGT: Field curvature, generalized, tangential FCUR: Field curvature 场曲 FICL: Fiber coupling efficiency FOUC: Foucault analysis G