硬币清分机电动-BetecIdeen.DOC

Servicing manual Ver1.0 Coin counter (electrical)　　 1. Spare part name Lid Coin hopper Display cover Disc Pedestal Cover of lid button Draw Lid button DC socket Connector 2. Attention： Coins that are bent and chipped or dirty coins will not enter the counting mechanism. At every time, you add the coins whose quantity can not over the 2/3 position of the coin hopper. B、Don’t open the lid when coin counter is working. If do, please fill coins to hopper to sort and count again. C、The motor will stop automatically when the draw is full in continuous counting and sorting. Please remove sorted coins from the draws. Otherwise, it will occur jamming, miss counting, miss sorting and harms the machine. D、If you notice that one or more coins (in good condition) experience difficulty entering the counting mechanism,using a stick or pencil, push them towards the feeding slot. E、After all sorting and counting every time, please clean the optical sensor A point(See figure) and the black metal disk . 3. Display cover 4. Instruction for operation ON/OFF ·Press ON/OFF，The unit will check automatically by itself, in the meantime, the display shows“0.00”. ·Press ON/OFFagain，the machine begins to sort and count, it will stop when press the ON/OFF one more time. ?Press ON/OFF for 3 second, the unit switch off. C/Q Button ?This button controls the two (value or number) alternative modes of coin counting operation. When the unit is turned ON, it is set by default in the “C”(value) mode. To activate the “Q”(number)mode, press the C/Q button for 3 seconds. A “beep” signal indicates the mode change. CLEAR Button ?The button erases the amount or number from the display. 5. Connecting of PCB A、DC socket B、STP C、Motor D、Display PCB E、CPU Board F、Receiving sensor G、16PIN flat cable H、Sending sensor I、Sensor 6. Testing and adjustment 6.1、Testing function 6.1.1　If the unit is switched on, the electronics undergo a self test. This may result in one of the following error messages: E-1