GE系列PDU原理文档.doc

Last Revised: December 2004 This module contains the following sections: Section 1 - Overview Section 2 - NGPDU Physical Description Section 3 - NGPDU Service Overview Section 4 - NGPDU Electrical Specifications Section 5 - NGPDU Drawings Section 6 - NGPDU LEDs Section 7 - NGPDU Control Board Switches and Fuses 1??Overview The PDU provides a single location to connect input power for the entire CT system. Its function is to provide the following features to the System: Compensation means for a wide range of input voltages via tap selection Provide required system AC power from a single source Provide High Voltage DC power for x-ray generation Provide power for gantry axial rotation Provide a means for emergency shutdown of all x-ray and drives power circuits Provide system AC power circuit protection Provide an interface for an external UPS connection Meet the requirements of IEC601 for both radiated and conducted emissions The PDU is designed to comply with United States Federal Regulations and the European Medical Device Directive. It bears the certification marks of a United States National Recognized Test Laboratory with Canadian deviation or a Canadian certified test house. Each unit is identified as being in compliance by being labeled with the official mark(s) of each respective agency. While in the stand-by mode, the NGPDU does not generate sound levels in excess of 50dbA, when measured at a distance of one meter from the nearest cabinet surface, in any direction. 2??NGPDU Physical Description 2.1??Mechanical Enclosure The enclosure has a front, rear and top access covers. The top cover is installed on the frame with a captive fastener in the middle of front edge. The front cover weighs less than 22 lbs (10 kg). A single full-width Lexan safety shield is provided under the front cover. It extends ?” below the top front edge of the assembly to the bottom of all HVDC Supply components, including the PDU Control Board. The rear cover is held in place by two