GeiPilot Techinical Seminar培训课件.ppt

For Internal Use Only GP Technical Seminar JinNan March 2009 Geo-Pilot Technical Seminar Brief Introduction Pre Job Working After job Special Comments Dinner Brief Introduction Point to bit system Long gauge bit Pre Job – Job Preparation Down Hole Tools GeoPilot PWD MWD FEWD Surface equipment GeoSpan Pluming kit MWD Unit Laptops Software INSITE Compass Planit QQ Pre Job – Bit Selection Anti-balling Less blades 12-1/4” FSF2563 PDC Nozzles: 5X16+2x20 (TFA 1.59) 8-1/2” FMF3553 PDC Nozzles: 3x16+1x14 (0.89) W/restrictor: 3x20+2x18 (1.42)+34/32 Pre Job – Hydraulics Calculation Pressure below PWD: GP9600 needs 450 psi, GP7600 needs 475 psi. Need further testing on fields MWD settings Working Surface settings (INSITE, GeoSpan) M/up BHA SHT and RIH Casing shoe Drilling Soft formation drilling Hard stringer drilling Reporting POOH L/D Working – Surface Settings INSITE GeoSpan Working – M/UP BHA Working – SHT and RIH GP Confidence test Tool Download Oil Status checking Working – Break in the seals Ensure that the Seals are broken in on the GP tool prior to circulation. Rotate at 5rpm for 2 min Rotate at 10rpm for 2 min Rotate at 20rpm for 2 min Rotate at 40rpm for 2 min Rotate at 60 rpm for 2 min REMEMBER: No Pumps when break in seals, normally in Casing 注意： 润滑密封时不开泵，通常在套管里进行 Working - How to drilling Casing shoe? Fill pipe and establish circulating parameters, wash down with good flow one stand before tagging cement or rubber plug. 钻具中灌满泥浆, 建立循环, 然后缓慢下放钻具直至探到水泥塞. If seals haven’t been broken in DO IT. Before Circulation commenced above the cement, ensure that the Seals are broken on the GP tool. No pumping when broken seals. 如果GP的密封没有润滑, 请先GP的密封润滑. 注意: 润滑密封时不开泵. Ensure that the Geo-Pilot is set in the “Zero” deflection position. 确保GP的设置在中性状态. Working - How to drilling Casing shoe? Drill cement, float and shoe track with low weight 40-60 rpm and full flow rate. Once completely satisfied that the plugs have been drilled, WOB may be increased to facilit