440EP开发方案.pdfVIP

AMCC PowerPC 440EP 开发方案 关键词: PowerPC,处理器,嵌入式系统,PCI,NAND,RISC,ROM,DMA, 摘要: AMCC公司的PowerPC 440EP是高端应用的嵌入式处理器,提供高性能低功耗的解决 方案,具有大量的外设接口以及片上功率管理特性. PowerPC 440EP包括有高性能RISC处 理器,浮点单元,DDR SDRAM控制器,PCI总线接口,外接ROM和外设控制,DMA,以太网端口, 串行端口,IIC接口,SPI接口,USB端口,NAND闪存接口和通用I/O.本文介绍了PowerPC 440EP (PPC440EP) 的主要性能,方框图以及AMCC 440EP 评估套件的主要性能亮点和详 细的电路图. AMCC公司的PowerPC 440EP是高端应用的嵌入式处理器,提供高性能低功耗的解决方案, 具有大量的外设接口以及片上功率管理特性. PowerPC 440EP包括有高性能RISC处理器, 浮点单元,DDR SDRAM控制器,PCI总线接口,外接ROM和外设控制,DMA,以太网端口,串行 端口,IIC接口,SPI接口,USB端口,NAND闪存接口和通用I/O.本文介绍了PowerPC 440EP (PPC440EP)的主要性能,方框图以及AMCC 440EP 评估套件的主要性能亮点和详细的电 路图. Designed specifically to address high-end embedded applications, the PowerPC 440EP (PPC440EP) provides a high-performance, low- power solution that interfaces to a wide range of peripherals and incorporates on-chip power management features. This chip contains a high-performance RISC processor, a floating point unit, DDR SDRAM controller, PCI bus interface, control for external ROM and peripherals, DMA with scatter-gather support, Ethernet ports, serial ports, IIC interfaces, SPI interface, USB ports, NAND Flash interface, and general purpose I/O. Technology: CMOS Cu-11, 0.13μm. Package: 35mm, 456-ball standard plastic ball grid array (E-PBGA), with and without lead (RoHS compliant). Typical power (measured): Less than 3W at 533MHz, 2.5W at 400MHz. Supply voltages required: 3.3V, 2.5V, 1.5V. PowerPC 440EP 主要特性: • PowerPC® 440 processor core operating up to 667MHz with 32KB I-cache and D-cache with parity checking. • Selectable processor:bus clock ratios of N:1, N:2. • Floating Point Unit with single- and doubleprecision and single-cycle throughput. • Dual bridged Processor Local Buses (PLBs) with 64- and 128-bit widths. • Double Data Rate (DDR) Synchronous DRAM (SDRAM) interface operating up to 133MHz with ECC. • DMA support for external peripherals, internal UART and memory. • PCI V2.2 interface (3.3V only). Thirty-two bits at up to 66MHz. • Programm