英文恒速解码说明书.docVIP

Multi-Protocol Receiver/Driver Module Operating Manual （Please read it carefully before using） 一、Equipment general states： The module is used as a front control equipment with DVR. Operation is simple and easy, it has strong ability and steady performance, and is light, RS485 is used as communication because it has one strong capability of preventing from interfering. The module has 3 groups of supplementary function control, brush, lamplight, camera power control. 二、Parameters Performance： Input voltage： 24VAC+10% Output power：10-20W The voltage for Lens：12VDC/300mA The voltage for camera；12VDC/1A Communication：RS-485 Address Range：0-255 三、Notice： This module is unsuitable to install in inflammable place. Input voltage is 24V AC. If more than 10 exist in your system, we suggest using a RS-485 divider to obtain system stability. Baud Rate must be consistent with that of DVR. Set correct address according to your design。 四、Parts Name： No. Name Explanation 1 Baud Rate You can set your expected baud rate for RS-485. 2 Protocol SW Protocol switch , by which you can set your expected protocol 3 Address SW Address switch, by which you can set the address of this device 4 Jumper RS-485com munication interface impedance option, factory setting is high ( Open), most far one set up for 120 (Close) 5 RS-485 The socket for RS-485 6 Lens socket The interface is between Lens and this module 7 DC12V 12V DC output, regulated maximum for 1A 8 AC24V 24V AC input 9 Pan Control Pan actions 10 LED State indicator, when CPU works Ok it flashes slowly, when receives control signals, it flashes faster 五、System connection： In a system, the jumper of the most far decoder should be set to 120 ohm( close) The maximum length of RS-485 line should not exceed 1200 meters. if more than 10 devices in a system , for improving systematic stability we suggest to use a control signal amplifier/ divider. When setting up RS-485 shielded twinning line, please ensure that the RS-485 l