振动法测试胶合木梁弹性模量的方法研究-中南林业科技大学学报.PDF

第35 卷 第4 期 中 南 林 业 科 技 大 学 学 报 Vol. 35 No. 4 2015 年4 月 Journal of Central South University of Forestry Technology Apr. 2015 Doi:10.14067/j .cnki.1673-923x.2015.04.018 http : // 振动法测试胶合木梁弹性模量的方法研究 王解军，夏滴洋，陈 晓 （中南林业科技大学土木工程与力学学院，湖南长沙4 10004 ） 摘 要：在简支条件下 , 应用振动无损检测法测定了胶合木梁的固有频率并算得其弹性模量值，同时采用振动分 析有限元法计算胶合木梁频率值和用静载试验测定其弹性模量。通过对振动测试、振动分析及静载试验共 3 种 方法得到的结果进行比较，证明了振动法测试胶合木梁弹性模量的可行性和准确性。 关键词：胶合木梁；振动测试与分析；固有频率；弹性模量；静载试验 中图分类号：S781.2 文献标志码：A 文章编号：1673-923X(2015)04-0105-04 Study on vibration-based detection methods for testing elastic modulus of glued laminated beams WANG Jie-jun, XIA Di-yang, CHEN Xiao (School of Civil Engineering and Mechanics, Central South University of Forestry and Technology, Changsha 410004, Hunan, China) Abstract: Under the condition of simple-supported, by adopting vibration NDT method, the natural frequency of glued laminated beams were measured and the elastic module values of the beams were also computed. Meanwhile, by using vibration analysis finite element method, the glulam beams frequency values were calculated and the glulam beams elastic modulus were determined through static tests. The comparisons among the results of vibration testing, vibration analysis and static load tests were conducted, the comparative results proved the feasibility and accuracy detecting glued laminated beams ’ elastic modulus with vibration methods. Key words: glued laminated beams; vibration-based detection and analysis; natural frequency; elastic module; static load test 胶合木结构为含水率不高于 18% 、厚度在 1 试件材料及制作方法 20 mm ～ 45 mm 、宽度较小、长度较短的锯材， 本次实验胶合木梁选取单层板规格为 2 1