毕业设计(给水处理厂的设计 处理水量为6万立方米天)[精品].doc

毕业设计(给水处理厂的设计 处理水量为6万立方米天) . 摘 要 本设计主要是给水处理厂的设计，处理水量为6万立方米/天，该厂的水源为地表水，水质情况良好，水库位于该城市给水处理厂东北方向，水厂位于城市北面，原水水质其中的一些常规的检测项目符合《生活饮用水水质卫生规范（2001）》的要求，需要处理的为水源的浊度、残渣及细菌的灭活。由于水源水质良好无需预处理及深度处理，所以该水厂的处理工艺流程为常规处理工艺。即：原水→混凝→沉淀→过滤→消毒→用户。主要构筑物为：机械絮凝池、斜管沉淀池、移动罩滤池和清水池。水厂布置采用了直角型，水厂地面标高22.00米，服务水头40-45米。 关键词：给水厂；低浊度；工艺流程 . . ABSTRACT This design is the design of the main water treatment plants, water treatment for 60000 m3 / day, the water surface water, water quality for good conditions, the city water supply plant reservoir located at northeast, north of the city waterworks, raw water quality and some of the conventional detection projects that comply with 《Life in the drinking water quality health standards (2001)》 requirement, Need to deal with water for the turbidity, residues and bacterial inactivated. Because the source good water quality and deep treatment without pretreatment, so the water treatment process for conventional process. Namely: raw water-coagulation sedimentation and filtration, disinfection, and users. The main structures for: mechanical flocculation pool, destabilize inclined pipe, mobile cover and QingShuiChi filters. Decorate adopted orthogonal model waterworks, waterworks ground elevation 22.00 meters, service head 40-45 meters. KEYWORDS: Water treatment plant; Low turbidity; Process . . 目 录 前 言 .................................................. 1 第一章 给水厂处理设计任务书 .............................. 2 1.1 设计题目 ............................................. 2 1.2 工程设计背景 ......................................... 2 1.3 本给水处理厂毕业设计的主要内容 ....................... 2 1.4 毕业设计的要求 ....................................... 3 第二章 给水处理工艺流程和给水处理构筑物的选择 ........... 5 2.1 设计原则 ............................................. 5 2.2 厂址选择 ............................................. 5 2.3 方案类型设计进行方案说明 ............................. 6 2.4 各种构筑物的对比及选型 ....................