以太网通道+VLAN+STP+HSRP+3层交换配置.doc

以太网通道+VLAN+STP+HSRP+3层交换配置 以太网通道+vlan+stp+hsrp+3层交换配置由于水平有限,不对的地方还望高手指教,这里先谢过了.由于cisco的packet tracer 5.2还不支持hsrp,所以只写出了配置步骤.先上拓扑图.路由器ra的配置步骤,这里没有涉及到路由器的很多配置,都是很简单的基本配置,不在详细说明,直接上show rra#show s% ambiguous command: show sra#show rbuilding configuration...current configuration : 838 bytes!version 12.2no service timestamps log datetime msecno service timestamps debug datetime msecno service password-encryption!hostname ra!!!!!!!!!!no ip domain-lookup!!!!!!interface fastethernet0/0ip address 192.168.2.1 255.255.255.0duplex autospeed auto!interface fastethernet1/0ip address 192.168.1.1 255.255.255.0duplex autospeed auto!interface serial2/0no ip addressshutdown!interface serial3/0no ip addressshutdown!interface fastethernet4/0no ip addressshutdown!interface fastethernet5/0no ip addressshutdown!router ripversion 2network 192.168.1.0network 192.168.2.0network 192.168.3.0network 192.168.4.0network 192.168.5.0network 192.168.6.0!ip classless!!!!!!!!!line con 0exec-timeout 0 0logging synchronousline vty 0 4login!!!end2.3层交换机的配置.第一部分s3a配置]enable //进入特权模式configture terminal //进入配置模式hostname s3a //更改交换机名字为s3aline console 0 //登陆控制台接口exec-timeout 0 0 //配置超时间为永不超时,不过这会引起安全问题,建议合理设置.no ip domain-lookup // 禁止域名解析,防止输入错误命令解析浪费时间logging s //配置输入同步interface range f0/1-6 //进入接口1-6switchport mode trunk //设置接口为trunk(中继)模式vtp 配置vtp mode server //设置vtp模式为服务器模式vtp domain bobo //定义一个名为bobo的域名,整个vtp域共享vlan 2 //创建vlan 2vlan 3 //创建vlan3vlan 4 //创建vlan4stp 配置spanning-tree vlan1 root primary //设置vlan1 在s3a上为根网桥spanning-tree vlan2 root primary //设置vlan2 在s3a上为根网桥spanning-tree vlan3 root secondary //设置vlan3 在s3a上为非根网桥spanning-tree vlan4 root secondary //设置vlan4 在s3a上为非根网桥spanning-tree backbonefast以太网通道配置interface range f0/1-2 //进入接口f0/1-2channel-group 1 mode on //配置以太网通道1hsrp配置interface vlan 1 //进入vlan1standby 1 ip 192.168.3.254 //配置虚拟ip地址,实现hsrp的关键standby 1 priority 200 //设置优先级为200standby 1 preempt //配置占先权standby 1 track