最新检具设计方案中英文资料.pptxVIP

B515 Checking Fixture Phase II Huangyan 5/1/2018 1 Date 15-10-11 B515 检具-黄岩 5/1/2018 2 Swivel form check template min two numbers Provided 至少应有两个样板刀 5/1/2018 3 Max line 3mm from nominal line Min line should be “Tolerance specified in cad” Part Nominal line Trim line marking for all checking fixture 名义修边线 板件 距离名义修边线3mm的最大修边线 最小修边线的公差应符合图纸的要求。 所有检具划修边线 5/1/2018 4 A B A- You provided diamond pin it is not acceptable please provide tapper pin with minimum and maximum tolerance B- You provided straight pin instead of that please provide tapper pin with minimum and maximum tolerance as shown in th