S0401D-08埋地钢管防腐说明书12.docVIP

DESCRIPTION OF ANTICORROSIVE COATING FOR OUTSIDE OF BURIED WELDED PIPE 埋地钢管外防腐说明书 D 2007.12 Approved by Owner on Dec 4,2007 C 2007.9 Approved by Owner on Sept 11,2007 REV DATE DESCRIPTION DESIGN CHECK REVIEW APPROVAL PT.PLN （PERSERO） OWNER’S DWG. NO. PT.PLN （PERSERO）JASA MANAJEMEN KONSTRUKSI JOB NO. E07007 印度尼西亚拉布湾2×300MW燃煤电站 PLTU 2 Banten Labuan (2×300MW) 工 程 Project 施工图设计阶段 Detail Design Stage 批 准 Approval 校 核 Check Description of anticorrosive coating for outside of buried welded pipe 埋地钢管外防腐说明书 审 核 Review 设 计 Design 日 期 Date 2007.9 比 例 Scale 图号 DWG.NO F289S-S0401C-08 版本号 REV: C  Contents 1、Method of anticorrosive coating work 防腐做法 2、Requirement of anticorrosive coating structure 防腐层结构要求 3、Requirement of anticorrosive coating construction process 防腐涂料施工工艺 4、Inspecting standard of constructions quality for anticorrosive coating 防腐涂料施工质量检验标准 5、Supplement and repairs of anticorrosive coating 防腐涂料的补口及补伤 The epoxy bituminous anticorrosive coating is used for buried steel pipe in this project. All the coating must conformity with coherent standard. 本工程埋地钢管防腐涂料采用环氧煤沥青。所用涂料应符合相关标准。 Method of anticorrosive coating work 防腐做法 Coating layers consist of two fiberglass fabrics and four anticorrosive coating layers. When brushing, first stage is brushing one layer priming coating on the surface of protection area, brush one layer finishing coating, after priming coating dry out, then entwine one layer fiberglass fabric that be impregnated by finishing coating. Fiberglass fabric must be tightened and its surface shall be flat without crease and salience. When entwining the fiberglass fabric, along the axial direction of pipe, the lap width shall be 20~25cm. In addition lap length between two pieces fabrics shall be 100~150mm.At above stage, it must ensure that finishing coating filling in all mesh of fabric and doesn’t droop from the fabric. After fiberglass fabric dry out, then entwine the secondary fiberglass fabric with the