SO 标准件13.pdfVIP

S E L F - C L I N C H I N G S TA N D O F F S SELF-CLINCHING STANDOFFS These standoffs, which use the proven self-clinching design, install with a squeeze in punched or drilled round holes – and become permanently mounted in the thin sheet. PEM brand standoffs are installed with their heads flush with one surface of the mounting sheet. When blind-threaded types are used, outer sheet surfaces are not only flush, but closed as well. Unthreaded standoffs are also available for spacing multi-panel assemblies. Dimensions: Unified – Dimensions shown in inches. Where tolerances are Always look for the “One or not indicated, standard tolerances are ± .01 in. for Two Groove” two-place decimals and ± .005 in. for three-place trademarks to be decimals. sure you are getting genuine PEM brand standoffs Metric – Dimensions shown in millimeters. Where tolerances are not indicated, standard tolerances are ± 0.25 mm for one-place decimals and ± 0.13 mm f