官方说明书intersil HIP1012A 数据手册.pdf

HIP1012A ® Data Sheet March 2004 FN4419.6 Dual Power Distribution Controller Features The HIP1012A is a HOT SWAP dual supply power distribution • HOT SWAP Dual Power Distribution Control for +5V and controller. Two external N-Channel MOSFETs are driven to +12V or +5V and +3.3V distribute power while providing load fault isolation. • Provides Fault Isolation At turn-on, the gate of each external N-Channel MOSFET is • Programmable Current Regulation Level charged with a 10µA current source. Capacitors on each gate (see the Typical Application Diagram), create a • Programmable Time Out programmable ramp (soft turn-on) to control inrush currents. • Charge Pump Allows the Use of N-Channel MOSFETs A built in charge pump supplies the gate drive for the 12V • Power Good and Overcurrent Latch Indicators supply N-Channel MOSFET switch. • Enhanced Overcurrent Sensitivity Available Overcurrent protection is facilitated by two external current sense resistors. When the current through either resistor • Redundant Power On Controls exceeds the user programmed value the controller enters the • Adjustable Turn-On Ramp current regulation mode. The time-out capacitor, CTIM, starts charging as the controller enters the time out period. Once • Protection During Turn-On CTIM charges to a 2