官方说明书intersil ISL95710 说明书.pdf

ISL95710 ® Digitally Controlled Potentiometer (XDCP™) Data Sheet August 31, 2006 FN8240.3 Terminal Voltage ±2.7V to ±5V, 128 Taps, Features Up/Down Interface • Non-Volatile Solid-State Potentiometer The Intersil ISL95710 is a digitally controlled potentiometer • Up/Down Interface with Chip Select Enable (XDCP). The device consists of a resistor array, wiper switches, a control section, and nonvolatile memory. The • DCP Terminal Voltage ±2.7V to ±5.5V wiper position is controlled by a Up/Down interface. • 128 Wiper Tap Points The potentiometer is implemented by a resistor array - Wiper position stored in nonvolatile memory and composed of 127 resistive elements and a wiper switching recalled on power-up network. Between each element and at either end are tap • 127 Resistive Elements points accessible to the wiper terminal. The position of the - Typical RTOTAL tempco = ±50ppm/°C wiper element is controlled by the CS, U/D, and INC inputs. - End to end resistance range ±20% The position of the wiper can be stored in nonvolatile memory and then be recalled upon a subsequent power-up operation. • Low Power CMOS - Standby current, 1µA The device can be used a