解放J6载货车制动系统设计毕业论文.doc

解放J6载货车制动系统设计 摘 要 β曲线，初步选择合适的制动力分配系数。通过设计经验对制动器的结构形式进行选择，绘制并验证利用附着系数与制动强度的关系曲线。设计制动器的结构参数与摩擦系数，对摩擦衬片的磨损特性校核计算，对驻车制动和制动距离进行校核计算。对制动器主要零部件的结构进行设计与强度计算，选择与设计制动驱动机构的结构型式。对制动器主要零部件如制动蹄进行有限元分析，校核了强度。 关键词：ECE  Brake System Design of FAW J6 Truck Abstract Automotive brake can slow down or even stop the moving car, maintain the downhill car’s speed, so that the car has been suspended remain intact. Automotive braking is one of the main performance of the vehicles, with the development of automotive technology, the rapid increase in the highway, the increasing of the traffic density and vehicle speed increases, and its importance has become more and more apparent. Braking is directly related to traffic safety, major accidents are often associated with the long braking distance, skidding when emergency brake and other circumstances, so the cars braking performance is an important guarantee for driving in the car safely. In this paper, it describes the air brake system systematic and elaborated through the design of FAW trucks braking system. In the design of the vehicle braking system, drawing the ideal brake force distribution I curve according to the vehicle braking parameters provided by the design task book firstly. Using the least squares method to determine the synchronous adhesion coefficient in empty load and full-load conditions, calculate the brake system power distribution coefficient, draw the β curve and select the appropriate brake force distribution coefficients initially. Select the structure of the brakes through design experience. Draw and verify a relation curve between the use of the brake friction coefficient and strength. Design the structural parameters and the coefficient of friction brakes, check for wear characteristics of the friction linings and the parking brake and the braking distance is calculated and checked. Design the structure of the main components of the brakes and check the strength. Select and design the drive mechanism of brakes. Cond