IEEE_std_C37.011 IEEE Application Guide for Transient Recovery Voltage for AC High-Voltage Circuit Breakers Rated on a Symmetrical Current Basis精编.pdfVIP

IEEE Std C37.011-1994 (Revision of IEEE Std C37.011-1979) IEEE Application Guide for Transient Recovery Voltage for AC High-Voltage Circuit Breakers Rated on a Symmetrical Current Basis Sponsor Switchgear Committee of the IEEE Power Engineering Society Approved September 22, 1994 IEEE Standards Board Abstract: Procedures and calculations necessary to apply the standard transient recovery voltage (TRV) ratings for ac high-voltage circuit breakers rated above 1000 V and on a symmetrical current basis are covered. The capability limits of these circuit interrupting devices are determined largely by the TRV. TRV ratings are compared with typical system TRV duties. Keywords: high-voltage circuit breakers, transient recovery voltage The Institute of Electrical and Electronics Engineers Inc. 345 East 47th Street, New York, NY 10017-2394, USA Copyright © 1995 by the Institute of Electrical and Electronics Engineers, Inc. All rights reserved. Published in the United States of America. ISBN 1-55937-467-5 No part of this publication may be reproduced in any form, in an electronic retrieval system or otherwise, without the prior written permission of the publsiher. IEEE Standards documents are developed within the Technical Committees of the IEEE Societies and the Standards Coordinating Committees of the IEEE Standards Board. Members of the committees serve voluntarily and without compensation. They are not necessarily members of the Institute. The standards developed within IEEE represent a consensus of the broad expertise on the subject within the Institute as well as those activities outside of IEEE that have expressed an interest in participating in the development of the standard. Use of an IEEE Standard is wholly voluntary. The existence of an IEEE Standard does not imply that the