实验二GPIO程序.docVIP

#include DSP281x_Device.h // DSP281x Headerfile Include File #include DSP281x_Examples.h // DSP281x Examples Include File // Prototype statements for functions found within this file. void delay_loop(void); void Gpio_select(void); void start(void); int *PTR,i=0; void main(void) { // Step 1. Initialize System Control: // PLL, WatchDog, enable Peripheral Clocks // This example function is found in the DSP281x_SysCtrl.c file. InitSysCtrl(); // Step 2. Initalize GPIO: // This example function is found in the DSP281x_Gpio.c file and // illustrates how to set the GPIO to its default state. // InitGpio(); // Skipped for this example // For this example use the following configuration: Gpio_select(); // Step 3. Clear all interrupts and initialize PIE vector table: // Disable CPU interrupts DINT; // Initialize PIE control registers to their default state. // The default state is all PIE interrupts disabled and flags // are cleared. // This function is found in the DSP281x_PieCtrl.c file. InitPieCtrl(); // Disable CPU interrupts and clear all CPU interrupt flags: IER = 0x0000; IFR = 0x0000; // Initialize the PIE vector table with pointers to the shell Interrupt // Service Routines (ISR). // This will populate the entire table, even if the interrupt // is not used in this example. This is useful for debug purposes. // The shell ISR routines are found in DSP281x_DefaultIsr.c. // This function is found in DSP281x_PieVect.c. InitPieVectTable(); // Step 4. Initialize all the Device Peripherals: // This function is found in DSP281x_InitPeripherals.c // InitPeripherals(); // Not required for this example // Step 5. User specific code: GpioDataRegs.GPBDAT.all =0xFF00; //通过GPIOB7给CLR引脚一个低电平 delay_loop(); //延迟 PTR=(int *)0X060; //地址指针PTR指向0060H for(i=0;i=7;i++) //将八个状态字存入60H开始的内存单元 { switch(i) { case 0: *(PTR+i)=0X0FFFB; break; //0060单元的值为FFFE case 1: *(PTR+i)=0X0FFF7; bre