FW-Training-cn－1.1.ppt

Step 2: 分配接口到安全区 Network Interfaces (Edit) set interface int-name zone zone-name ns208- set interface e3 zone L2-Demo Step 3a: 配置VLAN1 的IP 地址 Network Interfaces Edit (VLAN1) Use for Interface IP when terminating VPNs Use Manage-IP as destination address of PING, telnet, Web UI, etc. set interface vlan1 ip address/mask ns208- set int vlan1 ip /24 set interface vlan1 manage-ip address ns208- set int vlan1 manage-ip 00/24 Step 3b: 选择广播的方法 Flooding (default) 如果MAC表中没有，原数据包将向所有的接口进行广播——除了流入数据包的接口。 ARP/Trace-Route 如果MAC表中没有, ARP 或 traceroute 将向所有的接口进行广播——除了流入数据包的接口。 Network Interfaces Edit (VLAN1) set vlan1 broadcast arp set vlan1 broadcast flood Step 3c: 配置VLAN1 的服务 允许所有的管理服务 Web UI, Telnet, SSH, SNMP, SSL, NS-GlobalPro (nsmgmt) 选择指定的管理服务 Network Interfaces Edit (VLAN1) set interface vlan1 manage ns208- set int vlan1 manage set interface vlan1 manage [service] ns208- set int vlan1 manage web ns208- set int vlan1 manage ssl ns208- set int vlan1 manage nsmgmt Step 4: 在每个安全区中配置不同的管理服务 Network Zones Edit (V1-Trust) set zone name manage [service] ns208- set zone v1-dmz manage web 透明模式的检查工具 Get interface Get ARP Get mac-learn Get session Get interface name ns208- get interface ethernet1 Interface ethernet1: number 0, if_info 0, if_index 0, mode xparent, port vlan 1, sess token 9 link up, phy-link up/half-duplex vsys Root, zone V1-Trust, vr trust-vr *ip /0 mac 0010.db22.23f0 ping enabled, telnet enabled, SSH enabled, SNMP enabled web enabled, ident-reset disabled, SSL enabled, nsmgmt enabled webauth disabled DHCP-Relay disabled bandwidth: physical 100000kbps, configured 0kbps, current 0kbps total configured gbw 0kbps, total allocated gbw 0kbps ns208- Get arp ns208- get arp IP Mac VR/Interface State Age Retry PakQue abc3241244dc trust-vr/v1-trust STS 0 0 50 00065bd2ff42 trust-vr/v1-trust VLD 1151 0 0 ARP Entry Number 2/1024, No Free Entry C