毕业设计（论文）-PLC冰柜测试输送生产线控制系统设计.doc

XXXXXXXXXXXXXX 本科生毕业设计（论文） 学院（系）： 专 业： 学 生： 指导教师： 完成日期 2011 年 5 月 XXXXXX本科生毕业设计（论文） ontrol System Design of Freezer Test Transfer Production Line 总计： 毕业设计（论文） 38页 表 格： 5 个 插 图： 22 幅 冰柜测试输送生产线控制系统设计 [摘 要]本论文是设计一个由PLC控制的冰柜测试输送生产线。主要是以PLC为控制核心，变频器为辅助元件，电机作为执行元件。首先通过对系统控制要求的分析，画出程序流程图，之后在相应的编程软件中编写控制程序，从而通过PLC控制冰柜箱体在多条生产线中的进出功能，确保安全、畅通地按照既定工艺进行箱体传送。通过分析，分别对其硬件设计，PLC选用西门子S7-300。软件是应用西门子公司专门为S7-系列PLC设计开发的STEP7软件 [关键词]可编程逻辑控制器；控制系统；编程； Control System Design of Freezer Test Transfer Production Line Abstract: This paper designs a controlled by PLCs deep freezers test conveying line. This design mainly takes the PLC as control core, inverter as auxiliary components, motor as executive components etc. Firstly draw the program flow chart according to the analysis of the system’s require on controlling, then design the program in the corresponding software so as to reach the function of controlling the freezer cabinet getting in and out in several production by the PLC, and ensure cabinets can be transmitted safety and free according to the established process. A series of other hardware of control requirements through analysis and draw the program flow chart and in the corresponding software written by PLC control procedures to control in the cooler cabinet many production and function, ensure safe and smooth in accordance with established process cabinet to transmit. Through the analysis of its hardware design, respectively, and selects Siemens S7-300 series PLC. Software development is the application of Siemens S7-300 / specially for design and development of 400 series PLC STEP7 software. This topic through the software and hardware design meets the relevant instruction, to improve the accuracy, security system, through adjusted achieve the expected effect. Key words: Programmable logic controller；control system；pro