毕业设计（论文）-点火系统波形分析.docVIP

目 录 中英文摘要 2 第1章 绪 论 4 1.1引言 4 1.2 点火系统概述 4 第2章 点火系统检测连接及点火波形种类、特点 6 2.1点火系统检测连接方法 6 2.2点火波形种类 7 2.3次级点火波形的特点 9 第3章 点火波形分析 11 3.1点火波形分析方法 11 3.2各类点火系波形 11 3.2.1触点式点火系波形 11 3.2.2无触点点火系波形 12 3.3次级点火波形可查明的故障 13 3.4分析次级点火波形的要点 14 第4章 故障波形分析 18 4.1典型故障波形分析 18 4.1.1初级电压分析 18 4.1.2次级电压波形分析 20 4.2常见次级点火故障波形分析 21 结论 23 致谢 24 参考文献 25 关键词：点火系统；点火波形图；波形分析；故障波形分析 Abstract: The development of automotive electronics, increasing the breadth of applications, especially computer and network technology for the automotive electronics has brought fundamental change. Therefore, the maintenance of todays cars is not a simple mechanical repairs, but as one of mechanical and electronic maintenance. Since the maintenance of electronic control components more abstract, to the vehicle maintenance technology raised new challenges, many service personnel and stop looking, feeling and mysterious. Automotive electronic control system technology, the modern car has become a high-tech crystal, which requires car fault diagnosis technology to high-tech direction. The traditional way of fault diagnosis fault diagnosis did not meet the requirements of modern vehicles, especially for fault diagnosis of electronic control system must be the use of advanced testing equipment, advanced mode. Waveform analysis techniques used in the automotive repair industry, vehicle fault diagnosis can greatly improve the speed and accuracy of detection by waveform analysis, the oscilloscope can display the various parameters of electrical signals, using these parameters we can determine whether the electronic signal waveform Normal, and then, through the waveform analysis can further check out the circuit, sensors, actuators and control circuits and computer parts such as the failure to repair. This paper describes the vehicle ignition system waveform connection, detection, analysis; combined with a deep analysis of waveform image of automotive fault type, location, reason. So that scholars have a glance of profoun