4_水泥系统解决方案.pptVIP

Overview Examples概述 Burner Pipe喷煤管 Nose Ring出窑口 Kiln Hood窑头罩 Cooler冷却机 Inlet Chamber烟室 Calciner分解炉 Anchors arrangement锚固件安装 For the burner tip, anchors density must be increased在喷煤管头部，锚固件的密度应该增加 For remaining zone, anchoring pattern must be lighter对于其他部位，锚固件的数量可以稀疏一些。 Expansion Joint 膨胀缝 To avoid formation of snowman on the burner tip, it is recommended to install an air blaster or cast a concrete triangular block at the upper part. 为了避免在喷煤管顶部形成积料，可以在上部安装一个空气炮或将头部顶端的浇注料浇筑成三角形 To reduce clinker abrasion on the bottom part of the burner especially with grate cooler process, the lining on the