多乐士（Dulux）.docVIP

多乐士（Dulux） Guide to the use of Dulux latex paints 1. Please read the instructions before construction 2, should use high-quality construction tools, before using the new wool brush should first use detergent suitable, to remove grease, drum should be wetted with water before use, the use of roller must be supporting the use of pallets, recommend the use of short cylinder. 3. Fully stir the paint in the tank after opening the tank. 4, if necessary, add proper amount of water according to the instructions, not excessive dilution. To avoid excessive brush or roller coated paint, construction 5. 6, has diluted the paint not back to the original packaging. 7. Please use the opened tank as soon as possible. 8, when the substrate temperature is less than 5 degrees or environmental humidity is greater than 85%, please do not work. 9. The construction tools should be cleaned immediately with clean water and soap after construction clearance or completion. 10, deep color topcoat may need lower dilution and more coating layers, it is recommended to use roller construction, please refer to ICIs dark construction guidelines. Correct use of ICI latex paint | The wall plastering brush after ICI latex paint is the most common technical problems, is a few months or a year after the wall is easy to appear a lot of yellow, serious pieces of map like, very beautiful, this is usually due to the construction side with cheap water sand plaster wall and directly backing the aftermath. With the change of climate, the salty component will absorb moisture, and the salt and nitrate will permeate from inside to outside, which will corrode the ICI and make the wall yellow. To solve the wall yellowing, in addition to the use of genuine materials, you must also use the standard operating procedures. Usually the experience and practice is: wall plaster must use ordinary portland cement and sand to freshwater wharf, cement sand plaster wall, with high-quality Shuangfei powder plus 107 adhesive plast