注塑指导薄壳技术.pptVIP

為了有足夠的壓力充填薄的型腔，流道壓力降最好不要超過機器可提供射壓的15%。 使用較傳統流道大1.25到1.4倍大的流道。 更有進者，選擇熱流道加上斷面積較大的閥式澆口以降低壓力降到期望值。 In order to have sufficient pressure to fill the thin-wall cavity, the pressure drop through the runner system should not exceed 15% of the available machine injection pressure. This is accomplished by designing melt delivery channels 25 to 40% larger than conventional ones and selecting hot runner system including a valve gate design which increases the flow area at the gate. 薄殼技術Thin-wall Technology 熱流道內徑一般大於13mm，不可有尖角和死區。 採用外熱式加熱器才是正途。 為了能以高壓射出，大的閥式澆口必須安裝，以免形成障礙。 Hot runners often require a mi