基于MIMO-OFDM系的正交空时分组码毕业论文外文翻译.docVIP

On Orthogonal Space-Time Block Codes for MIMO-OFDM Systems Space-time code in mobile communication system, and orthogonal desing in multiple- antennas scneme are dicsussed. By the methods, data is encoded using a space- time block code and is split into several streams which are simultaneously transmitted by antennas. So a maximum- likelihood decoding algorithm can be used at the receiver to achieve the maximum diversity order Introduction Most work on wireless communications had focused on having an antenna array at only one end of the wireless link — usually at the receiver. Seminal papers by Gerard J. Foschini and Michael J. Gans[1], Foschini[2] and Emre Telatar[3] enlarged the scope of wireless communication possibilities by showing that for the highly-scattering environment substantial capacity gains are enabled when antenna arrays are used at both ends of a link. An alternative approach to utilizing multiple antennas relies on having multiple transmit antennas and only optionally multiple receive antennas. Proposed by Vahid Tarokh, Nambi Seshadri and Robert Calderbank, these space–time codes (STCs) achieve significant error rate improvements over single-antenna systems. Their original scheme was based on trellis codes but the simpler block codes were utilized by Siavash Alamouti,and later Vahid Tarokh, Hamid Jafarkhani and Robert Calderbank to develop space–time block-codes (STBCs) [4]. STC involves the transmission of multiple redundant copies of data to compensate for fading and thermal noise in the hope that some of them may arrive at the receiver in a better state than others. In the case of STBC in particular, the data stream to be transmitted is encoded in blocks, which are distributed among spaced antennas and across time. While it is necessary to have multiple transmit antennas, it is not necessary to have multiple receive antennas, although to do so improves performance. This process of receiving diverse copies of the data is known as diversi