2500td新型干法水泥生产线烧成系统窑头工艺设计 毕业论文.docVIP

摘 要 本次设计的任务2500t/d水泥熟料新型干法水泥生产线工艺设计。”三风机系统”。本次设计所选篦冷机为MLS3626，以及由2—?4500的旋风收尘器和BFRS1200-2x8袋收尘组成的三风机系统，除尘效率大于99%。 关键词：新型干法物料平衡 主机平衡ABSTRACT The design of the task of cement clinker 2500 t/d NSP cement production line which system kiln head process design.Used at home and abroad, the raw material grinding system there are three: dry milling and grindingsystem,vertical mill grinding system and the final roller press system. The inadequate of ball mill system are：low grinding efficiency consumption; large noise; etc; Final grinding roller press system have the defect are the particle size, operation and maintenance, reliability, and so on. So this design useds grinding capacity, energy consumption, feed particle size and other aspects have performance superior of roller mill system.By the nember of fan that controls the air quantity and air pressure balance in kiln and mill system,the raw material grinding system and the waste gas processing system at kiln back end was divided into double fan system and three fan system .For reduced power consumption ,environmental protection and other considerations ,the design of the exhaust treatment system uses the “three-fan system”. Based on material balance calculations and equipment selection calculation,求出配方后，根据配方比例和原、燃料数据分析，计算三大平衡，即物料平衡、主机平衡、储库平衡，并制定物料平衡表、主机平衡、储库平衡表。dryddd The design selected cooler Shenyang Heavy production MLS3626“three fan system ” by the 2—?4500 cyclone dust collector and BFRS1200-2x8 Bag dust collector, dust removal efficency is greater than 99%.朗读 显示对应的拉丁字符的拼音 字典 Key words: dry process mass balance the host balance raw material grinding system Dust collection bags 目 录 摘 要 I ABSTRACT II 第一章 前言 - 1 - 1.1 水泥的发展情况 - 1 - 1.2 生料磨粉磨系统 - 2 - 1.3 收尘系统 - 3 - 1.4设计方案的确定 - 4 - 第二章 配料计算 - 5 - 2.1 生料配料的基本步骤 - 5 - 2.2 原始数据 - 5 - 2.2.1基本条件 - 5 - 2.3 配料计算过程 - 6 - 2.3.1煤灰掺入量 - 6 - 2.3.2计算干燥原料配合比 - 6 - 2.3.3计算湿原料的配合比 - 7 - 第三章 物料平衡表 - 9 - 3.1 物料平衡 - 9 - 3.1.1 所需原料数据 - 9 - 3.1.2 计算步骤和计算公式 - 9 - 3.1.3 编制物料平衡表