采煤机牵引部改进计毕业论文.docVIP

摘　　要 本设计是对MG300/701-WD采煤机牵引部进行改进设计。该采煤机为双滚筒无链电牵引采煤机，单个牵引电机功率为45KW，主要用于采高1.6 ～3.2m≤15°，在实际使用中存在一定的局限性。现根据双行星机构中第一级的各齿轮抗弯曲强度尚有裕量，而第二级各齿轮的抗弯曲强度过低的。因此，在保证各齿轮具有足够的接触强度和弯曲强度的前提下，通过采用保持二级行星减速器整体尺寸不变，减小其相应差轮的模数，增加其齿数，提高传动比，使采煤机牵引力增大。应用于工作面倾角在15°～5°情况下，实现大倾角煤层条件下的高档普采。 关键词 采煤机 牵引部 改进 行星机构 Asbtract This design is for the machine of MG300/701-WD coal mining pull department improve design. This machine of coal mining is no chain electricity for two cylinders to pull the machine of coal mining , is single to pull generator for power 45 kW, is used to pick high 1.6 mainly ～ 3.2 m Zong pick face can pick more hard coal quality. It pulls department, is formed mainly by 2 level directly tooth deceleration organization and two level planet deceleration organizations, pass through motor drive have so realized the entire machine of coal mining pull to walk, it meet inclination is smaller than 15?, in actual use, there is certain limitation. Now according to each gear of first level in two planet organizations fight flexural strength have yet rich, and each gear of second level fight flexural strength low. Therefore each gear in guarantee has enough contact strength and flexural strength, through adopting in maintenance two level planet overall sizes do not change , reduce its little modulus , increase its tooth number, have raised deceleration proportion, make the machine haulage of coal mining increase. In face inclination between15?and35?condition take off , realization is high grade and general as the big inclination condition of coal seam takes off to pick. Keywords coal cutter leading unit improve planet organization 目 录 摘　　要 I Asbtract II 第1章 绪 论 1 1.1 国内外电牵引采煤机的发展现状 1 1.1.1国外电牵引采煤机技术特点及发展趋势 1 1.1.2国内采煤机的发展现状 2 1.1.3国内采煤机使用上存在的问题 3 1.2 课题的提出 3 1.3 简述MG300/701-WD采煤机 4 1.3.1MG300/701-WD采煤机的使用范围及主要组成 4 1.3.2 MG300/701-WD采煤机的工作原理及主要技术参数 4 第2章　机械系统传动方案的确定 7 2.1 设计方案和主要参数的确定 7 2.1.1设计方案的确定 7 2.1.2主要参数的确定 7 2.2 改进后的采煤机主要性能参数 9 第3章 齿轮的设计计算及强度校核 10 3. 1 第三级行星机构Z5