D-5034-04织物断裂强度与延伸率.docVIP

Designation: D5034 - 95 (Reapproved 2001) 标准号：D5034 – 95（2001年重新批准） Standard Test Method for Breaking Strength and Elongation of Textile Fabrics (Grab Test)1 织物断裂强度和延伸率的标准测试方法（抓样强力试验） This standard is issued under the fixed designation D 5034; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. 本标准的固定标准号为D5034；随后的数字表明了该标准的原版采用的年份或者最近一次修改的年份。在括号内的数字表明了上次通过重新批准的年份。上标中的小的正数表明上次修改或者重新获准后进行的编辑修改。 1. Scope 范围 1.1 This test method covers the grab and modified grab test procedures for determining the breaking strength and elongation of most textile fabrics. Provisions are made for wet testing. 本测试方法规定了测量纤维制品断裂强度和延展率的试验程序以及经过修改后的试验程序。本标准还给出了湿式测试法。 1.1.1 The grab test procedure is applicable to woven, nonwoven, and felted fabrics, while the modified grab test procedure is used primarily for woven fabrics. 本试验程序适用于帆布织品、非纺织织品以及油毡织品，而经过修改后的试验程序主要是适用于帆布制品。 1.2 This test method is not recommended for glass fabrics, or for knitted fabrics and other textile fabrics which have high stretch (more than 11 %). 本测试方法不适用于玻璃织物、针织物以及其他延伸率较大（大于11％）的纤维制品 note 1—For the determination of the breaking force and elongation of textile fabrics using the raveled strip test procedure and the cut strip test procedure, refer to Test Method D 5035. 注意1—如果使用开线法或者切断法测试程序确定纤维织品的断裂力或者延伸率，相关试验方法请参照测试方法D5305。 1.3 This test method provides the values in both inch-pound units and SI units. Inch-pound units is the technically correct name for the customary units used in the United States. SI units is the technically correct name for the system of metric units known as the International System of Units. The values stated in either acceptable metric units or in other units shall be regarded separately as standard. The values stated in each system may not be exact