FE-7-TPMS系统培训课件.docxVIP

FE-7胎压监测系统培训Training on FE-7 Tyre Pressure Monitoring System研究院慈溪分院/电子电器部Cixi Branch of Research Institute/Electronics Department2015.11.2511/25/2015系统概述System Overview系统功能System Function售后维修推荐操作Recommended Operations for After-sales Service智能胎压监视系统简称TPMS 。Smart tyre pressure monitoring system is known in short as TPMS.FE-5/7车型采用的是大陆的第二代胎压传感器，能实时监测轮胎的温度，轮胎压力和离心加速度等信息，并发射相关的射频信号给BCM进行处理。然后BCM通过CAN总线将轮胎压力信号和温度信号等发送给仪表进行显示。当发生TPMS传感器故障，胎温过高，胎压过低，快速漏气时，仪表将提示客户。FE-5/7 model adopts Mainland Generation-II tyre pressure sensor. The sensor monitors tyre temperature, pressure and centrifugal acceleration and then sends relevant radio-frequency signals to BCM for processing. After that, BCM sends via CAN bus the tyre temperature and pressure signals to IPC to display. In case of a TPMS sensor fault, excessively high tyre temperature or excessively low tyre pressure, or quick leakage, IPC will remind the driver. 胎压监测系统仅当车速大于25公里/小时时工作，当车辆静止或者以小于25公里/小时的速度行驶时，系统不会实时监测胎压状态。TPMS only works when the vehicle speed is higher than 25 km/h; the system will not monitor the tyre pressure state in a real-time manner when the vehicle is stationary or is running at a speed lower than 25 km/h.胎压监测系统由以下部件组成：TPMS is composed of the following components:1. TPMS 左后轮传感器1. TPMS rear wheel sensor LH2. TPMS 右后轮传感器2. TPMS rear wheel sensor RH3. TPMS 左前轮传感器3. TPMS front wheel sensor LH4. 中央集控器总成BCM4. Central controller assembly BCM5. TPMS 右前轮传感器5. TPMS front wheel sensor RH6. 组合仪表6. Combination instrument?胎压监测传感器通过无线通讯传输数据，胎压监测传感器接受125 KHz 3.9 Kbits/s 低频信号。无线通讯传输依靠射频信号，射频信号覆盖应传输范围。传感器安装在轮胎气门嘴上，由传感器金属杆固定，传感器外壳以及金属杆构成的角度将符合立中车轮的标准轮毂说明。? The tyre pressure sensor transmits data via wireless communication and receives low-frequency signals of 125 KHz 3.9 Kbits/s. Wire communication transmission is realized via radio-frequency signals which cover the needed transmission scope. The sensor is installed on the tyre valve and fixed by a metal rod. The angle formed by the sensor casing and the metal rod conforms