GPS-电梯调试.docVIP

GPS-2电梯调试 MITSUBISHI elevator GPS-2 debugging information 2009-06-12 11:27:27 Author: Source: Internet When the tension of the elevator rope changes, the weighing device is replaced, and the elevator itself changes due to the decoration, the weighing data should be re written. The specific steps shall be carried out in accordance with the process shown in figure 3. MITSUBISHI elevator GPS-2 debugging a lot of content, the following only on a few major aspects of explanation. 1. write the weighing data When the tension of the elevator rope changes, the weighing device is replaced, and the elevator itself changes due to the decoration, the weighing data should be re written. The specific steps shall be carried out in accordance with the process shown in figure 3. Figure 3 is the elevator no-load weighing data writing process, a data writing process and elevator weighing this is basically the same, just press the LD0/LD1 switch to LD1 direction. In addition to weighing the elevator data, it is necessary to adjust the weighing device of the elevator as follows: The elevator no-load, when the brakes release, the elevator car upward trend, then turn the switch WGHG toward F direction adjustment; The elevator no-load, when the brakes release, the elevator car downward trend, the rotating switch WGHG toward 0 direction adjustment; ? in normal operation, do not switch the WGH0 and WGHG switches to 0 position. 2. floor data write When the elevator is disorderly, the level is not allowed or the elevator is re weighed and the data is written, the floor data is required to be written. The floor data write method should follow the process shown in figure 4. It is particularly important to note that some floors of some buildings or homes are imaginary floors (no stopping floors), and elevators do not stop at these floors. When installing the elevator, the diaphragm of the floor is a short magnetic barrier, and the DZ indicator on the P1 main computer board will not shine when the