二00八LEEDCaseStudy个案研究.pptVIP

NC-project Nokia BDA Campus Energy Efficient Design for LEED LEED Assessment Summary (2007-10-19) SS Credit 8: Light Pollution Reduction Intent Minimize light trespass from the building and site, reduce sky-glow to increase night sky access, improve nighttime visibility through glare reduction, and reduce development impact on nocturnal environments. Requirements FOR INTERIOR LIGHTING The angle of maximum candela from each interior luminaire as located in the building shall intersect opaque building interior surfaces and not exit out through the windows. OR All non-emergency interior lighting shall be automatically controlled to turn off during non-business hours. Provide manual override capability for after hours use. SS Credit 8: Light Pollution Reduction AND FOR EXTERIOR LIGHTING Only light areas as required for safety and comfort. Do not exceed 80% of the lighting power densities for exterior areas and 50% for building facades and landscape features as defined in ASHRAE/IESNA Standard 90.1-2004, Exterior Lighting Section, without amendments. EA Prerequisite 1: Fundamental Commissioning of the Building Energy Systems Intent Verify that the building’s energy related systems are installed, calibrated and perform according to the owner’s project requirements, basis of design, and construction documents. Commissioned Systems Commissioning process activities shall be completed for the following energy-related systems, at a minimum: ? Heating, ventilating, air conditioning, and refrigeration (HVACR) systems (mechanical and passive) and associated controls ? Lighting and daylighting controls ? Domestic hot water systems ? Renewable energy systems (wind, solar etc.) EA Prerequisite 2: Minimum Energy Performance Intent Establish the minimum level of energy efficiency for the proposed building and systems. Requirements Design the building project to comply with both— ? the mandatory provisions (Sections 5.4, 6.4, 7.4, 8.4, 9.4 and 10.4) of ASHRAE/IESNA Standard 90.1-2