厨房水电（Kitchen hydropower）.docVIP

厨房水电（Kitchen hydropower） Water circuit reconstruction process and standard Waterway section Material prompt According to the material quoted by the company, the materials conforming to the national standard should be selected, and the aluminum plastic pipe can be absolutely used Two) matters needing attention in construction 1 general water changes a top left, hot and cold water nozzle must be horizontal mixing valve hole distance like in 150mm 2 the laying of the pipeline must be flat and straight 3 hot and cold water pipes are all into the wall, the groove must check the depth of the slot 4 waterway reconstruction to complete the pipeline pressure test, the experimental pressure should be less than 20-30 minutes 5 shower tub mixed faucet right and left position, installed in the middle of the bathtub (bath must be determined size), height is 150-200mm in the bathtub, massage bathtub according to the type of water outlet reserved 6 the water inlet of the toilet can be placed in the place where the toilet can be blocked The hot and cold water faucet of the 7 column basin is 500-550mm away from the ground, and the water channel should be installed in the column 8 before installing bathtubs, waterproof should be checked. If there is no waterproof or waterproof is damaged, waterproof should be redone 9 when the water heater is in and out, the inlet valve and intake valve must be considered and should be installed in the corresponding position 10 the installation of kitchen and toilet pipeline, the size of the pipe in the wall should take into account the final size of the wall tiles affixed, that is to consider the thickness of the wall brick The design of 11 water pipe renovation should consider the installation position of the washing machine faucet, the layout of the water, and pay attention to the location of the socket is appropriate 12 the layout of water supply pipeline should be reasonable 13 water inlet should be equipped with indoor valve, the installation mu