C9故障码读取英文带图高级班培训.pptVIP

* DTC 故障部件 故障现象 可能的原因 维修方法 备注 1EA ECU internal Supply Voltage too low Insufficient voltage supply of a CJ940 component: Low battery voltage, defective wiring, internal defect of the EDC Check the battery for sufficient voltage supply, check wiring. If defect remains replace EDC (internal defect) 1EB Atmospheric Pressure Sensor failure Ambient pressure sensor inside ECU is defect Replace ECU (not necessary if never running in high altitude and if turbocharger without VGT) 2E1 ECU Hardware: Low Side Power Stage Short to Ground or Battery Short circuit of wiring to external source or inside relay Check wiring or replace relay * 1.检查ECU供电电压 2.检查ECU接地 3.检查ECU状态 4.检查水温传感器 5.检查曲轴转速传感器 6.检查凸轮轴传感器 7.检查燃油温度传感器 8.检查加速踏板传感器 9.检查空气压力传感器 10.检查共轨压力传感器 11.检查油量计控制阀 * A.燃油温度传感器 B. 发动机凸轮轴转速传感器 C. ECU D. 高压油泵燃油调节阀 E. 启动电机 F. 机油温度压力传感器 G. 交流发电机 H. 空气压力温度传感器 I.压缩机调节装置 L. 水温传感器 M.发动机线束接头 N. 发动机曲轴转速传感器 * * DTC 故障部件 故障现象 可能的原因 维修方法 备注 165 Injector Cylinder 5 failure 第5缸喷油器故障 第5缸喷油器不工作 连接中出现短路,喷油器线圈存在问题,控制单元可能出现问题 检查线束,必要时更换喷油器 166 Injector Cylinder 6 failure 第6缸喷油器故障 第6缸喷油器不工作 连接中出现短路,喷油器线圈存在问题,控制单元可能出现问题 检查线束,必要时更换喷油器 * A power stage component energizes the system transistors and simultaneously observes the current flow in the high-side and low-side switching branch by sensing resistors. If there is a deviation from the expected current flow the component detects specific errors and reports them to the ECU. This error message is then rearranged so it holds information on performed injections, errors of cyls. on the same bank, bank specific errors and cylinder specific errors. The rearranged error message is then compared to applicable error patterns and if there is a match the failure corresponding to the matched pattern is output. If an error message doesnt match any pattern the defect is treated as unclassifiable error. Monitoring is performed once per camshaft revolution. Injector Cylinder 1 failure 故障码:161 Power stage component 给系统的晶体管上电,同时通过sensing resistors观察高压端和低压端电流的流动.如果监测到的