微纳米技术燃电池中的微纳米技术2014.ppt

2.1.3 硅基膜电极的加工 Optical microscopic photograph of Si-MHA: (a) 10 um, (b) 30 um, (c) 50 um. International Journal of Hydrogen Energy 34 (2009) 6457 2.1.3 硅基膜电极的加工 Fabrication of catalyst layer and micro-temperature sensor 化学气相沉积Pt并进行湿法腐蚀来分别制备导电层或者微型温度传感器以及催化层。 International Journal of Hydrogen Energy 34 (2009) 6457 2.1.3 硅基膜电极的加工 Schematic of flow channel with a Microtemperature sensor Optical microscopic photograph of Si-MHA combined with a micro-temperature sensor Chart of cathode plate Chart of anode plate International Journal of Hydrogen Energy 34 (2009) 6457 2.1.3 硅基膜电极的加工 uPEMFC experimental results obtained with 10, 30, 50um holes at 20, 30 and 40 deg. Performance of micro-fuel cell obtained with/without a micro-temperature sensor International Journal of Hydrogen Energy 34 (2009) 6457 2.1.4 硅基电池组的加工 Conventional bipolar fuel cell stack Flip-flop planar series interconnection Journal of Power Sources 112 (2002) 410 2.1.4 硅基电池组的加工 Sixteen-cell t with flip-flop interconnection Four-cell assembly Flow distribution pillars etched in silicon Silicon multi-cell etch sequence Journal of Power Sources 112 (2002) 410 2.1.4 硅基电池组的加工 Gas distribution path for four-cell assembly Polarization curves of four-cell assembly. The series interconnection does provide the voltage sum of each of its individual cells. However, the four individual cells do not exhibit uniform behavior. Journal of Power Sources 112 (2002) 410 2.2.1 金属基流场的加工 Cathode perforated current collector with parallel channel 采用300μm厚的304不锈钢板作为μDMFC极板的衬底材料。 微冲压技术是指当所成形的零件或结构尺寸处于亚毫米级或更小，主要包括微拉深、增量成形、微冲裁和微弯曲。 流道宽度深度为1000μm和370μm，支撑脊的宽度大约为400μm。由于微冲压成形技术的工艺特点，流道的横截面形状为等腰梯形。最后利用激光打孔技术在特定位置加工出输液孔与呼吸孔。 Image of the stamped flow field of a metal current collector International Journal of Hydrogen Energy 36 (2011) 2230 2.2.1 金属基流场的加工 SEM photographs of the current collectors Photograph of the metal-based uDMFC Oxygen, liquid saturation, and current density distribution on cathode catalyst layer International Journ