广域网路配置FR协议.pptVIP

第8章 广域网路由配置 本节内容 8.3 FR帧中继协议 学习目标 通过本章的学习，希望您能够： 理解FR协议工作原理 掌握FR协议配置方法 课程议题 课程议题 帧中继交换机接口参数 帧中继交换机交换表 帧中继交换机接口参数 帧中继交换机交换表 Purpose: This figure illustrates mapping the data-link connection identifier (DLCI) to the network layer address such as IP. Emphasize: The DLCI is of local significance, therefore, point out that the same DLCI can be used in multiple places in the network. Frame Relay connections are made using PVCs. The circuits are identified by the DLCI assigned by the service provider. Explain what Inverse ARP is used for. Static mapping can be configured instead of inverse ARP. * Layer 1 of 4: Purpose: This figure describes the Inverse ARP and LMI process. Emphasize: Step 1—Indicates that each router must connect to the Frame Relay switch. Note: The status inquiry messages are part of LMI operation. Explain what Inverse ARP is used for. Layer 2 of 4: Purpose: This figure describes the Inverse ARP and LMI process. Emphasize: Step 1—Indicates that each router must connect to the Frame Relay switch. Step 2—Discusses what information is sent from the router to the Frame Relay switch. Layer 3 of 4: Purpose: This figure describes the Inverse ARP and LMI process. Emphasize: Step 1—Indicates that each router must connect to the Frame Relay switch. Step 2—Discusses what information is sent from the router to the Frame Relay switch. Step 3—Discusses what the Frame Relay switch does with the received information. Layer 4 of 4: Purpose: This figure describes the Inverse ARP and LMI process. Emphasize: Step 1—Indicates that each router must connect to the Frame Relay switch. Step 2—Discusses what information is sent from the router to the Frame Relay switch. Step 3—Discusses what the Frame Relay switch does with the received information. Step 4—Discusses the sending of Inverse ARP messages. Layer 1 of 3: Purpose: This figure describes the Inverse ARP and LMI process (cont...). Emphasize: Step 5—Discusses how the Inverse ARP message is used to create the Frame