Cost Simulation in MFGPRO - Midwest User Group在mfgpro -美国中西部的用户组的成本模拟.pptVIP

Cost Simulation QAD Support Table Of Contents Overview Flow Chart Comparison of Standard Costing and Cost Simulation Review of Costs Before Changes “What if” Scenarios Cost Simulation Process Review of Costs After Changes  Cost simulation functions provide you with the ability to set up different cost scenarios and test the impact of cost changes. Simulation Cost Sets may be used to develop and store information for: “What If?” costs Budgeted costs Projected costs Historical costs You can set up the following: Work Center Labor Rates Work Center Burden Rates Subcontract Operation Costs Item Material Costs Overhead Costs Simulation roll-up functions look at these costs rather than the standards. This is the Cost Management menu. This is the Cost Simulation menu. Add Simulation Cost Set 30.1 Cost Set Maintenance Copy Existing Cost Set 30.3 Cost Set Copy to Cost set and 30.13.23 Item/Routing to Simulation Copy Define Elements30.13.1 Simulation Cost Element Maint Enter Costs30.13.5 Simul Item-Element Cost Maint 30.13.8 Simul Item- Element Cost Update 30.13.10 Simul Subcontract Cost Maint 30.13.13 Simul Work Center Rate Maint 30.13.16 Simul Work Center Rate Update Simulation CostRoll-Ups 30.13.18 Simulation Cost Roll-Up and 30.13.19 Simulation Structure Cost Roll-Up Review30.13.7 Simul Item-Element Cost Report Update Current Or GL Costs 30.3 Cost Set Copy to Cost Set and 30.13.22 Simulation to WC/Routing Copy Copy Costs To copy costs from another source, use: 30.13.9 Simul Item-Element Cost Copy Simul Item-Element Cost Copy copies direct costs from one simulation cost set to  another simulation cost set 30.3 Cost Set Copy to Cost Set Copies costs stored under one Cost Set Code to another Cost Set Code  30.13.23 Item/Routing to Simul Copy  Cop