Descriptive geometry （画法几何）.docVIP

Descriptive geometry 1（画法几何1） A single choice (only one option right, a total of 51 items) 1. drawing standards are standardized standards for standardization and standardization throughout the country. Some industries and departments have formulated ministerial standards, and the ministerial standards are: (A) reference function (B) use in parallel with national standards; (C) replacing national standards; (D) supplement to national standards The answer youve chosen is D [right] The correct answer: D Answer reference: 2. in civil engineering drawings, in addition to complying with the standards of construction engineering drawing and some trade standards, the national standards which must be observed are: (A) general drawing standards; (B) drawing standards for water conservancy and hydropower projects; (C) technical drawing standards (D) railway engineering drawing standards The answer youve chosen is C [right] The correct answer: C Answer reference: 3. drawings, letters and numbers can be written in italic italic or straight, head tilted to the right with the level of: (A) 45 degrees; (B) 60 degrees; (C) 75 degrees; (D) 80 degrees; The answer youve chosen is C [right] The correct answer: C Answer reference: In the 4. frame drawings is frame line, line drawing frame: (A) fine solid line (B) in thick lines. Solid line (C) The bold solid line (D) The answer youve chosen is C [right] The correct answer: C Answer reference: The 5. title bar is located in the bottom right corner of the drawing, drawing the outer line of the title bar: (A) arbitrary Linetype (B) fine solid line (C) in thick lines. Solid line (D) The answer youve chosen is D [right] The correct answer: D Answer reference: 6. if the length of the object is 1000mm and the drawing ratio is 1:20, the length of the drawing should be taken: (A) 100 (B) 1000 (C) 50 (D) 20 The answer youve chosen is C [right] The correct answer: C Answer reference: A scale of 7. is a prismatic column, and a scale should be used