Effects of high pressure, preliminary irradiation and heat ：高压力的影响，初步辐照和热.pptVIP

Infrared Spectroscopy IR (FTIR) Leonid Murin 1,2 1 Joint Institute of Solid State and Semiconductor Physics, Minsk, Belarus 2 Oslo University, Centre for Materials Science and Nanotechnology, Oslo, Norway OUTLINE Some general notes Electronic transitions Local Vibrational Mode spectroscopy BACKGROUND - WHAT IS MEASURED The light transmitted through a sample of thickness d with polished parallel surfaces is described as where: I0 is the light intensity incident on the sample α is the frequency dependent absorption coefficient R is reflectivity (R ≈ [(n-1)/(n+1)]2 ≈ 0.3 in the mid infrared) Electronic transitions Shallow donors and acceptors Group VI (S, Se, Te) etc Thermal double donors (as an example: L.I. Murin, V.P. Markevich, J.L. Lindstrom, M. Kleverman Spectroscopic observation of the TDD0 in silicon, Physica B 340–342 (2003) 1046–1050). Detection limit Calibration: α = 1 cm-1 corresponds approximately to NTDD = 1013 cm-3 Detection of α = 0.01 cm-1 (NTDD = 1011 cm-3) is reliable LVM spectroscopy “LVM spectroscopy assumes now a very central role among the large number of semiconductor characterization techniques which have been developed over the years and which are continuously refined and improved. When applicable, this technique allows, in many cases, the precise identification of impurity species and their crystal lattice location with excellent sensitivity. Besides, LVM spectroscopy with perturbations such as polarization of the probe light, uniaxial and hydrostatic stress, and isotope substitution can be highly successful in identifying the structure and composition of various kinds of defect complexes.” E.E Haller, Mat. Res. Soc. Symp. Proc. Vol. 378 (1995) 547-565. Detection limits Depend on: Measurement temperature (LT or RT) Sharpness of the lines Wavenumber position Detection limits normally are in the range 5x1013 – 1x1015 cm-3) * * *