表胶制备控逻辑图.docVIP

Surface Size Starch Dissolving Sequence 5501SQ1-101. 表胶淀粉溶解顺控5501SQ1-101 Purpose and function 目的和范围 To control the surface size starch dissolving. 控制表胶淀粉溶解。 Dosing set points are entered at MCS monitor display. 在MCS监视器中显示可以输入设置的计量点。 In AUTO-mode the sequence is started when dissolving tank level 5501LIC-112 is below the starting level limit and the dissolving permission is on. The starting level limit can be set at MCS monitor display. 在自动模式中，当溶解槽液位低于初始值时，开始这条逻辑顺控。初始液位限位可以在MCS监视器中显示。 Step 1 Idle 步骤1 闲置空转 Wait time 0 s control time - s 等待时间 0 s 控制时间 无 Actions: 动作： Conditions to the next Step: 进入下一步条件 - dissolving tank level 5501LIC-112 is below start limit; 溶解槽液位5501LIC-112处于起始液位以下 - enzyme tank level is not below low limit 5501LS-103; 反应媒槽液位高于5501LS-103低限 - water valve 5501LV1-111 is closed; 清水调节阀5501LV1-111处于关闭状态； - conditions for error step 7: 条件错误进入步骤7： - Dissolving permission is not on 溶解许可处于未开启状态（考虑到复位按钮功能，此处应为停机复位后待机状态，下同。） Step 2 Initialization 步骤2 初始化 Wait time 0 s control time 30 S 等待时间 0 s 控制时间 30 s Actions: 动作 - Conveyor 5501C001M1 to AUTO-mode 输送机5501C001M1投入自动模式 - Dissolving tank agitator 5501A001M1 to AUTO-mode 溶解槽搅拌器5501A001M1投入自动模式 - Initialization of the set values 初始化所有设定值 - Enzyme pump 5501P001M1 to AUTO-mode 反应酶泵5501P001M1投入自动模式 Conditions to the next step 进入下一步条件 - Above mentioned actions performed. 所有动作就位 - （空缺） - Conditions for error step 7: 条件错误进入步骤7 - Dissolving permission is not on 溶解许可处于未开启状态 Step 4 Water 步骤4 清水 Wait time 0 s control time 60 s 等待时间 0 s 控制时间 60 s Actions: 动作 - Dissolving tank level control 5501LIC-112 to AUTO-mode. 溶解槽液位控制5501LIC-112投入自动模式。 - （空缺） Conditions to the next step: 进入下一步条件： - When dissolving tank agitator 5501A001M1 is running 溶解槽搅拌器5501A001M1运行 - （空缺） - Conditions for error step 7: 条件错误进入步骤7： - Control time elapsed OR 控制时间超时 - Dissolvi