基本采样与保持电路.PPTVIP

* Chapter 5 Data Acquisition Circuits Prof. Dehan Luo 第五章 数据采集电路 Section One Sample and hold （第一节 采样与保持） 1、Architecture of data acquisition systems 2、Sample hold and Basic S/H circuit 3、S/H response characteristics Section Two Multiplexing circuits（第二节 多路开关电路） 1、Multiplexers 2、FET analog switches Section Three Analog to digital converters（第三节 模数转换器） 1、 Single slope or ramp 2、 Successive approximation 3、Dual slope 4、Parallel or ‘flash’ Section Four Digital to analog converters （第四节 数模转换器） 1、Binary weighted ladder 2、R-2R ladder 3、Pulse width modulation Intelligent Sensors System 5-1 School of Information Engineering Chapter 5 Data Acquisition Circuits Prof. Dehan Luo Section One Sample and hold 第一节 采样与保持 Architecture of data acquisition systems Intelligent Sensors System 5-2 School of Information Engineering Chapter 5 Data Acquisition Circuits Prof. Dehan Luo Sample hold and Basic S/H circuit 1、A Sample and hold (S/H) circuit has two basic operating modes（采样与 保持电路有两种基本工作方式） （a）Sample mode: The output follows the input （b）Hold mode: The output is held constant until sample mode is resumed （输出保持不变直到采样方式恢复） 2、The main application of S/H circuits is to hold the input signal to an ADC constant during conversion （采样保持电路主要应用是使加到ADC上的 信号在AD转换期间保持不变） Intelligent Sensors System 5-3 School of Information Engineering Chapter 5 Data Acquisition Circuits Prof. Dehan Luo Sample hold and Basic S/H circuit (Cont.)（续） 3、Basic S/H circuit （基本采样与保持电路） （1） Basic elements （基本元件）： Voltage followers（电压跟随器）， FET s