异步电动机毕业论文电磁设计计算_电机毕业论文.doc

兰州交通大学毕业设计（论文）兰州交通大学毕业设计（论文） - PAGE 20 - PAGE \* ArabicDash \* MERGEFORMAT - 18 -异步电动机毕业论文电磁设计计算摘 要本文主要针对Y2-200L-4型电机进行了电磁设计和计算。首先基于设计任务书给定的参数并结合相关的技术条件确定了与Y2-200L-4电机的电磁性能有关的主要尺寸，选择定、转子的槽数及槽配合，用CAD绘制出定、转子的槽型和线圈尺寸图，槽型分布图及绕组分布图。计算出每相串联导体数，串联匝数，槽满率等基本量，然后据此选定有关的材料。再在MATLAB中编程进行该电机的电磁计算，反复调整有关参数，使其技术指标符合任务书的要求，最终设计出符合任务书规定技术要求的电机。关键词：Y2-200L-4;定转子;绕组分布;电磁设计计算AbstractThis article mainly about electromagnetic design and calculation of Y2-200L-4 motor. First it determined the main dimensions related to the electromagnetic properties of the Y2-200L-4 motor based on the parameters of dsign task and technical conditions. Then it selected the number of slots of stator and rotor and right slots. I not only used CAD to draw size chart of stator, rotor and coil but also draw distribution of groove and winding. I calculated some basic amount such as the number of conductors in series per phase and slot fill factor. Then I selected the related materials. I have completed the electromagnetic calculations of this motor in MATLAB. Then I adjusted the parameters repeatedly. I did a lot of work to make its technical indicators meet the requirements of the mission statement. In the last I designed the motor that meet the requirements of the mission statement.Key Words: Y2-200L-4, stator and rotor, winding distribution, electromagnetic  TOC \o 1-3 \h \z \u HYPERLINK \l _Toc356829387 摘 要 PAGEREF _Toc356829387 \h 0 HYPERLINK \l _Toc356829388 Abstract PAGEREF _Toc356829388 \h 1 HYPERLINK \l _Toc356829389 1 绪论 PAGEREF _Toc356829389 \h 4 HYPERLINK \l _Toc356829390 1.1 工程背景 PAGEREF _Toc356829390 \h 4 HYPERLINK \l _Toc356829391 1.2 设计范围 PAGEREF _Toc356829391 \h 4 HYPERLINK \l _Toc356829392 1.3 设计依据 PAGEREF _Toc356829392 \h 4 HYPERLINK \l _Toc356829393 1.4 设计目标 PAGEREF _Toc356829393 \h 4 HYPERLINK \l _Toc356829394 1.5 本文的主要工作 PAGEREF _Toc356829394 \h 4 HYPERLINK \l _Toc356829395 2 三相异步电动机主要参数的确定 PAGEREF _Toc356829395 \h 5 HYPERLINK \l _Toc356829396 2.1 主要尺寸及气隙长度的确定 PAGE