毕业设计（论文）-2×60+1600MW火电厂电气部分设计.docxVIP

本科生毕业设计设计题目 2×60+1×600MW火电厂电气部分设计学 院 机 电 工 程 学 院 学生姓名 学号 专 业 电气工程及其自动化 年级 13级电气x5 指导教师 职称 高级教授 内蒙古农业大学教务处制年 月 设计概况本设计根据地区发电厂与电力系统的连接情况，按照相关的设计要求和规范，对厂用电进行了设计和计算，依据原始资料，要设计一座2×60+1×600MW凝汽式地区火电厂，首先根据原始资料给出的60MW机组和600MW机组的厂用负荷表，分别计算了60MW厂用负荷和600MW机组的厂用负荷，并分别确定了电压等级，根据厂用负荷选择了厂用变压器，分析设计出厂用电接线，之后对厂用电动机自启动作了校验。根据原始资料的4个电压等级，论证并设计出了主接线，对主变压器进行了选型，对于不同电压等级下的几个点也进行了短路计算，根据计算结果选择了电气设备，最后对发电厂厂区平面布置图进行了绘制，根据布置图设计了防雷和保护方案。关键词：发电厂、厂用电、电气主接线、变压器、电气设备、短路计算 Design surveyAccording to the design of the connection area of power plant and power system, in accordance with the design requirements and related specifications, the factory has been designed and calculated using electricity, according to the original data, to design a 2 * 60+1 * 600MW condenser in power plant, firstly, according to the original data given by the 60MW group and the 600MW unit plant with the load table, with load and load of 600MW unit plant 60MW was respectively calculated and determined according to the voltage level, the auxiliary load selection transformer, also designed the auxiliary power wiring, and the auxiliary motor for the self start checking. According to the 4 voltage level of the original data, demonstrated and designed the main wiring, the main transformer was selected for several points under different voltage of short circuit calculation, selection of electrical equipment according to the calculation results, the thermal power plant layout drawing, according to the layout design of the lightning protection and protection scheme.Key words: power plants, electrical main wiring, transformers, electrical equipment, short circuit 目录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc484621476 1绪论 PAGEREF _Toc484621476 \h 1 HYPERLINK \l _Toc484621477 1.1选题依据 PAGEREF _Toc484621477 \h 1 HYPERLINK \l _Toc484621478 1.2国内建设概况 PAGEREF _Toc484621478 \h 1 HYPERLINK \l _Toc4