单片机程序12-18B20和LD与EDA讲义.docxVIP

/***************数字中C程序设计*******************/#includereg52.h#includemath.h#define uint unsigned int #define uchar unsigned char/***************时间位变量定义********************/sbit mode=P3^7;sbit inc=P3^6;sbit dec=P3^5;sbit enter=P3^4;sbit point=P0^7;bit flag=1;sbit DQ=P1^1; //设定温度采集端sbit led=P2^7;//三色指示时钟sbit speaker=P2^6;//声音报警端口sbit d2=P2^5;sbit d3=P2^4;sbit d4=P2^3;sbit d5=P2^2;sbit d6=P2^1;sbit d7=P2^0;/*****************变量定义*************************/uchar t,hhour,lhour,hmin,lmin,hsec,lsec;uchar hour,min,sec,vmode; uchar ahour,amin;uchar m,n,deta;uchar day,week,mon;//定义日期uint year;uchar temp;//存放温度值uchar str[3];//存放温度分离值uchar code table[]={0x3f,0x06,0x5b,0x4f,0x66,0x6d,0x7d,0x07,0x7f,0x6f,0x00,0x00};//共阴型七段数码管0~9的断码uchar code choosebit[]={0x01,0x02,0x04,0x08,0x10,0x20};//P2^0~P2^5是6个数码管从地位到高位的位选uchar table1[]={31,31,29,31,30,31,30,31,31,30,31,30,31}; //闰年uchar table2[]={31,31,28,31,30,31,30,31,31,30,31,30,31}; //非闰年/**************************声明时钟调用子函数*********************************/void delay(uint z);void delay_spk(uint cnt);void mode0();void mode1();void mode2();void mode3();void mode4();void mode5();//显示日期void mode6();//显示温度void display(uchar t_hour,uchar t_min,uchar t_sec);/*****************声明ds18b20调用的子函数************************************/ uchar ReadTemperature(void); //读取温度void Init_DS18B20(void); //18b20初始化函数uchar ReadOneChar(void);//读一个字节void WriteOneChar(uchar dat); //写一个字节void delay_temperature(uint y); //延时函数void display_temperature();/********************主函数**************************************/void main(){ vmode=0;speaker=0; hour=0;min=1;sec=0; ahour=0;amin=3;led=0; year=2009;mon=05;day=25;week=01;//日期赋初值 TMOD=0x11;//设置定时器0,1为工作方式1 TH0=0xd8;//定时器定时10ms TL0=0xf0; TH1=(65536-5000)/256;TL1=(65536-5000)%256; IE=0X8a;//开定时器0,1中断 TR0=1;//启动定时器0 TR1=1;//启动定时器1 t=0;//赋显示初值 while(1) { switch(vmode) { case 0:mode0();break;//正常走时 case 1:mode1();break;//调整当前时间分钟 case 2:mode2();break;//调整当前时间小时 case 3:mode3();bre